This topic describes how to add a cloud data source HybridDB for MySQL.

Prerequisites

  • A HybridDB for MySQL database is created.
  • The username and password that you use to access the HybridDB for MySQL database are obtained.
  • The AccessKey ID and AccessKey secret used for authentication are obtained.

Procedure

  1. Click the Workspace tab. In the left-side navigation pane, click Data Sources.
  2. On the Data Sources page, click Create Data Source in the upper-right corner.
  3. In the Add Data Source dialog box, click the Cloud Data Sources tab and then the HybridDB for MySQL card.
    添加数据源
  4. In the Add HybridDB for MySQL Database dialog box, configure the parameters.
    Add a cloud data source HybridDB for MySQL
    Parameter Description
    Name The name of the data source. In this example, set the value to cloud data source_HybridDB for MySQL.
    Database Address The hostname or IP address of the database that is used as the data source.
    Port Number The port that you use to access the database. Default value: 3306.
    Database The name of the database that you want to access. In this example, set the value to quickbi_sla.
    Username The username that you use to access the database. In this example, set the value to quickbi_sla.
    Password The password that you use to access the database.
    VPC Data Source If the data source is connected over a VPC, select VPC Data Source and specify the relevant parameters.
    AccessKey ID The AccessKey ID that you use to purchase the instance where the database resides.
    Note This parameter appears only when you select VPC Data Source.
    AccessKey Secret The AccessKey secret that you use to purchase the instance where the database resides.
    Note This parameter appears only when you select VPC Data Source.
    Instance ID The ID of the database instance.
    Note This parameter appears only when you select VPC Data Source.
    Region The region where the database instance resides. In this example, set this value to China (Hangzhou).
    Note This parameter appears only when you select VPC Data Source.
  5. Click Test Connection to test connectivity with the database.
    Test connectivity with the database
  6. After the database passes the connectivity test, click OK.
    If a data source with the same configurations exists, a message that indicates a configuration conflict is displayed. You cannot add the same data source repeatedly.