This topic identifies the indicators associated with the Smart Access Gateway (SAG). You can check the status of a Smart Access Gateway (SAG) by checking its indicators.

SAG model Indicator Status description
SYS (system indicator) If the indicator is on, the system runs normally.

After you press the RST key (Reset key), the indicator goes off.

SAG-100WM LTE Indicates whether the SAG communication is normal.
  • On: The SAG is registered on the network.
  • Flashing: Data is being transmitted.
  • Off: The SAG is not registered on the network.
WAN Indicates the Ethernet status of the SAG.
  • On: The SAG is connected to the network through the Ethernet.
  • Flashing: Data is being transmitted.
  • Off: The SAG is not connected to the Ethernet.
WIFI Indicates the Wi-Fi connection status of the SAG.
  • On: The WLAN is enabled.
  • Flashing: Data is being transmitted.
  • Off: The WLAN is not enabled.
RUN Indicates the status of the SAG.
  • On: The SAG is powered on.
  • Flashing: The system operates normally.
  • Off: The SAG is powered off.
CLOUD Indicates whether the SAG is connected to Alibaba Cloud.
  • Flashing: The SAG is connected to Alibaba Cloud.
  • Flashing quickly: The SAG is restoring the default settings or restoring the system.
  • Off: The SAG is not connected to Alibaba Cloud.
SAG-1000 Power supply On: The SAG is powered on.
Alarm The alarm indicator has the following statuses:
  • Green: The SAG operates normally.
  • Yellow: A fault has occurred.
Cloud The alarm indicator has the following statuses:
  • Green: The connection to the cloud is normal.
  • Yellow: The connection to the cloud is faulty.