All Products
Search

This Product

    Edge Security Acceleration:Configure environments

    Document Center

    Edge Security Acceleration:Configure environments

    Last Updated:Nov 27, 2025

    After a version is deployed to an environment, you can change it by performing an upgrade, switch, or rollback.

    Create an environment

    1. In the ESA console, choose Websites, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments, and click Create Environment.

      Note

      You can set an environment to read-only only after it is created.

    3. On the Create Environment page, enter an Environment Name, set the filter rules and initial position, and then click OK.

    Edit an environment

    1. In the ESA console, choose Websites, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments > Edit.

    3. Edit the Environment Name > Version > Traffic Filter for This Environment > Read-only Environment, and then click OK.

      Note

      • If the environment is the first sequence, you can edit the version deployed in it.

      • When you set an environment to read-only, the version deployed in it also becomes read-only.

      • You can modify the traffic filters for all environments except the production environment.

    Change the version in an environment

    You can Promote, Roll Back, or switch the version deployed in an environment.

    Upgrade a version

    1. In the ESA console, choose Websites, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments > Promote.

    3. When you upgrade a version, a message appears with key information about the versions before and after the upgrade. After you confirm that the change is as expected, click OK.

      image

    Roll back a version

    1. In the ESA console, choose Websites, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments > Roll Back.

      Note

      • This operation rolls back the version deployed in the environment to the one that was previously deployed. You cannot perform a rollback if no version was previously deployed to the environment.

    3. On the Rollback Reminder page, check the information about the version to be deployed and its corresponding environment. After you confirm that the change is as expected, click OK.

      image

    Switch a version

    You can directly switch the version deployed in a specific environment. After you confirm the switch, the new version is immediately deployed and takes effect.

    1. In the ESA console, choose Site Management, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments.

    3. In the Overview area, find the environment that you want to change, and then select the target version.

      image

    Delete an environment

    1. In the ESA console, choose Websites, and in the Website column, click the target site.

    2. In the navigation pane on the left, choose Version Management > Environments > Delete, and then click OK.

      Note

      • Before you delete an environment, make sure that it is not receiving active requests. The system does not check for active requests. This action permanently deletes the environment and cannot be undone. Proceed with caution.

      • The production environment, which is the default environment created after version management is enabled, cannot be deleted.