This topic describes how to configure a Data Transmission Service (DTS) data source and obtain the values for the parameters that are required to configure a DTS data source.

Prerequisites

Lindorm Tunnel Service (LTS) is activated. For more information, see Activate LTS.

Procedure

  1. Log on to the ApsaraDB for HBase console.
  2. On the Clusters page, click the ID of the BDS Edition instance for which you want to configure a DTS data source.
  3. On the Basic Information page, click BDS in the UI Access section to go to the LTS console.
  4. In the left-side navigation pane of the LTS console, choose Data Source Management > Add Data Source on the page that appears.
  5. On the Add data source page, specify the parameters.
    Parameter Description
    Name Specify a name for the DTS data source.
    Data Source Type Select DTS.
    Parameters Configure information about the data source. You can obtain values of the required parameters in the DTS console.
    • In the DTS console, click the ID of the DTS task to go to the details page of the task. Then, click Task Management in the left-side navigation pane of the details page. On the page that appears, you can obtain values for the following parameters:Task management
      • topic: the name of the topic that you can use to subscribe to the DTS instance. In the preceding figure, the topic name is displayed in the field that is marked with ①.
      • proxyAddr: the endpoint of the DTS instance. In the preceding figure, the available endpoints are displayed in the field that is marked with ②.
    • Click Consume Data in the left-side navigation pane of the details page. On the page that appears, you can obtain values for the following parameters:Data consumption
      • sid: the ID of the consumer group. In the preceding figure, the consumer group ID is displayed in the field that is marked with ③.
      • username: the username of the consumer group. In the preceding figure, the username is displayed in the field that is marked with ④.
      • password: the password of the consumer group. If you forget the password, you can click Modify password in the Operation column to set a new password.
  6. Click Add.