This topic describes how to log on to Lindorm Insight in the ApsaraDB for HBase console.

Prerequisites

  • An ApsaraDB for HBase Performance-enhanced Edition instance is created. For more information, see Purchase a cluster.
  • The public IP address of the on-premises device that you want to connect to Lindorm Insight is added to a whitelist of the ApsaraDB for HBase Performance-enhanced Edition instance.
    • If your on-premises device runs a Linux operating system, you can run the curl ipinfo.io |grep ip command on the device to obtain the public IP address. The following figure shows a sample result.Obtain the public IP address
    • If your on-premises device runs a 64-bit Windows operating system, you can visit ipinfo from the device to obtain the public IP address.
    • For more information about how to add an IP address to a whitelist of an ApsaraDB for HBase Performance-enhanced Edition instance, see Configure IP address allowlists and security groups.
  • The password that you use to log on to the UI is reset. For more information about how to reset a password, see Reset the password used to access the cluster management system.

Procedure

  1. Log on to the ApsaraDB for HBase console.
  2. On the Clusters page, find the cluster that you want to manage and click the cluster ID.
  3. In the left-side navigation pane, click Cluster management.
  4. On the Cluster Management System page, click ClusterManagerInternet in the UI Access section.
  5. On the Log On dialog box, enter the username and password.
  6. Click Log On. The Lindorm Insight page appears.