:Modify endpoint services

This topic describes how to modify endpoint services. You can change the description and default maximum bandwidth, and specify whether to automatically accept connection requests from endpoints.

1. Log on to the VPC console.
2. In the left-side navigation pane, choose Endpoint > Endpoint Service.
3. In the top navigation bar, select the region where the endpoint service is deployed.
4. On the Endpoint Service page, click the service ID of the endpoint service that you want to modify.
5. In the Information section, perform the following operations to modify the endpoint service:
   • Specify whether to automatically accept endpoint connections

     Click Enable or Disable next to Automatically Accept Endpoint Connections, and then click OK in the message that appears.

   • Modify the description

     Click Edit next to Description. In the dialog box that appears, enter a new description, and click OK.

     The description must be 2 to 256 characters in length, and cannot start with http:// or https://.

   • Modify the default maximum bandwidth

     Click Modify next to Default Maximum Bandwidth. In the Change Bandwidth dialog box, specify a new bandwidth value, and then click OK.