This topic describes how to edit an event rule in the EventBridge console.

Prerequisites

Create an event rule

Edit the event target settings of the system event bus

To edit the event target settings of the system event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click System Event Bus.
  3. In the top navigation bar, select a region.
  4. On the Rules page, find the required rule and click Edit Event Targets in the Operations column.
  5. On the Edit Rule page, modify the settings of the event targets and click Save.

Edit the event pattern settings of the system event bus

To edit the event pattern settings of the system event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click System Event Bus.
  3. In the top navigation bar, select a region.
  4. On the Rules page, find the required rule and click Edit Event Pattern in the Operations column.
  5. On the Edit Rule page, modify the settings of the event pattern and click Save.

Edit the event target settings of a custom event bus

To edit the event target settings of a custom event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click Custom Event Buses.
  3. In the top navigation bar, select a region.
  4. On the Custom Event Buses page, find the required event bus and click Rules in the Operations column.
  5. On the Rules page, find the required rule and then click Edit Event Targets in the Operations column.
  6. On the Edit Rule page, modify the settings of the event targets and click Save.

Edit the event pattern settings of a custom event bus

To edit the event pattern settings of a custom event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click Custom Event Buses.
  3. In the top navigation bar, select a region.
  4. On the Custom Event Buses page, find the required event bus and click Rules in the Operations column.
  5. On the Rules page, find the required rule and click Edit Event Pattern in the Operations column.
  6. On the Edit Rule page, modify the settings of the event pattern and click Save.