This topic describes how to enable an event rule that is disabled in the EventBridge console.

Prerequisites

Disable an event rule

Enable an event rule of the system event bus

To enable an event rule of the system event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click System Event Bus.
  3. In the top navigation bar, select a region.
  4. On the Rules page, find the required rule and click Enable in the Operations column.
  5. In the Note message, click OK.
    On the Rules page, find the event rule that you enabled, and view its status in the Status column. Its status is Enabled.

Enable an event rule of a custom event bus

To enable an event rule of a custom event bus, perform the following steps:

  1. Log on to the EventBridge console.
  2. In the left-side navigation pane, click Custom Event Buses.
  3. In the top navigation bar, select a region.
  4. On the Custom Event Buses page, find the required event bus and click Rules in the Operations column.
  5. On the Rules page, find the required rule and click Enable in the Operations column.
  6. In the Note message, click OK.
    On the Rules page, find the event rule that you enabled, and view its status in the Status column. Its status is Enabled.